Tootekategooriad
Filter Pidurid Šassii Roolimine Jahutus/kliima Elektrisüsteem Lisad Jõuülekanne Väljalaskesüsteem Kere Süüte-/eelsüütesüsteem Mootor Klaasid/klaasipuhastus Valgustus Kütusesüsteemi seadmed Kabiinivarustus HooldusToode
Kirjeldus
Laoseis
Hind
(km-ga)
- for OE number: 210 325 0284
- Fitting Position: Rear Axle
- Thickness [mm]: 9
- Tootja: TRUCKTEC
- Thickness [mm]: 13
- Inner Diameter [mm]: 63
- Outer Diameter [mm]: 105
- Material: Rubber
- Number of Knobs: 3
- Fitting Position: Rear Axle
- Weight [kg]: 0.149
-
Nimetus: PUHVER,
VEDRUSTUS - Tootja: FEB
General Information: These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.
- Number of Knobs: 1
- Fitting Position: Rear Axle
- Thickness [mm]: 5
- Weight [kg]: 0.092
- Tootja: VAICO
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Thickness [mm]: 9
- Inner Diameter [mm]: 63
- Outer Diameter [mm]: 105
- Material: Rubber
- Number of Knobs: 2
- Fitting Position: Rear Axle
- Weight [kg]: 0.121
-
Nimetus: PUHVER,
VEDRUSTUS - Tootja: FEB
General Information: These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.
- Thickness [mm]: 9
- Inner Diameter [mm]: 63
- Outer Diameter [mm]: 105
- Material: Rubber
- Number of Knobs: 2
- Fitting Position: Rear Axle
- Weight [kg]: 0.121
- Nimetus: SW 10 56 0022
- Tootja: SWAG
General Information: These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.
- Height [mm]: 9
- Fitting Position: Rear Axle
- Weight [kg]: 0.133
- Tootja: VAICO
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Number of Knobs: 3
- Fitting Position: Rear Axle
- Thickness [mm]: 13
- Weight [kg]: 0.149
- Tootja: VAICO
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Thickness [mm]: 5
- Material: Rubber
- Number of Knobs: 1
- Fitting Position: Rear Axle
- Weight [kg]: 0.092
- Tootja: SWAG
General Information: These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.
- Length [mm]: 116
- Weight [kg]: 0.123
- Packaging length [cm]: 11.5
- Packaging width [cm]: 3.1
- Packaging height [cm]: 3.1
- Tootja: FEBEST
OE-numbri jaoks: A0029903020
- Thickness [mm]: 5
- Material: Rubber
- Number of Knobs: 1
- Fitting Position: Rear Axle
- Weight [kg]: 0.092
-
Nimetus: PUHVER,
VEDRUSTUS - Tootja: FEB
General Information: These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.
- Thickness [mm]: 13
- Inner Diameter [mm]: 63
- Outer Diameter [mm]: 105
- Material: Rubber
- Number of Knobs: 3
- Fitting Position: Rear Axle
- Weight [kg]: 0.149
- Tootja: SWAG
General Information: These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.
- Thickness [mm]: 17
- Inner Diameter [mm]: 63
- Outer Diameter [mm]: 105
- Material: Rubber
- Number of Knobs: 4
- Fitting Position: Rear Axle
- Weight [kg]: 0.149
-
Nimetus: PUHVER,
VEDRUSTUS - Tootja: FEB
General Information: These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.
- Fitting Position: Rear Axle
- Diameter [mm]: 102
- Height [mm]: 35
- Weight [kg]: 0.149
- Number of Knobs: 4
- Thickness [mm]: 17
- Tootja: VAICO
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Thickness [mm]: 17
- Inner Diameter [mm]: 63
- Outer Diameter [mm]: 105
- Material: Rubber
- Number of Knobs: 4
- Fitting Position: Rear Axle
- Weight [kg]: 0.149
- Tootja: SWAG
- Nimetus: SW 10 56 0024
General Information: These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.
- Thickness [mm]: 73
-
Inner Diameter [mm]: 27,
18 - Outer Diameter [mm]: 58.5
-
Material: PU
(Polyurethane), Rubber - Fitting Position: Front Axle
- Weight [kg]: 0.072
-
Nimetus: Puhver,
vedrustus - Tootja: FEB
General Information: These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.
- Fitting Position: Front Axle both sides
- Control/Trailing Arm Type: for control arm
- Nimetus: Rattakalde korrektuurkruvi
- Tootja: MAX
- Šassii: sõidukitele ilma elektr.vedrustusreguleerijata
- Thickness [mm]: 224
- Inner Diameter [mm]: 68
- Fitting Position: Front Axle
- Inner Diameter 1 [mm]: 88
- Weight [kg]: 0.09
- Tootja: FEB
- Lisainfo: FE40088
Material: EPDM (ethylene propylene diene Monomer (M-class) rubber) General Information: These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions. Nimetus: Kaitsekaan/kaitsekumm - Vedrustus/amordid DB P. CLA/CLS/C W204/A W176/B W246 LE/PR
- Fitting Position: Front Axle
- Height [mm]: 224
- Required quantity: 2
- replacement in pairs recommended:
-
Nimetus: Kaitsemts/
kaitsekumm, amort - Tootja: MEY
Piduri-/sõidudünaamika: ilma elektroon. sõidudünaamika regulaatorita sõidukite jaoks
Tootja: ZZVF
- Piduri-/sõidudünaamika: Elektro.sõidudünaam.regul.sõidukile
- Length [mm]: 208
- Width [mm]: 87
-
Material: PU
(Polyurethane), Plastic - Fitting Position: Front Axle
- Weight [kg]: 0.26
-
Nimetus: Puhver,
vedrustus - Tootja: FEB
General Information: These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.