Tootekategooriad
Filter Pidurid Šassii Roolimine Jahutus/kliima Elektrisüsteem Lisad Jõuülekanne Väljalaskesüsteem Kere Süüte-/eelsüütesüsteem Mootor Klaasid/klaasipuhastus Valgustus Kütusesüsteemi seadmed Kabiinivarustus HooldusToode
Kirjeldus
Laoseis
Hind
(km-ga)
-
Fabrication Number: ECP-
AR- 013 - Tootja: NTY
Tavatellimus saadetakse E, K ja R kell 14:00. Kaup saabub kuni 3 tööpäevaga. Tavatellimusse lähevad ainult positiivse laojäägiga tooted. Lisaks tavatellimusele on võimalik tellida ka Express kulleriga (24h). Kulleri hinda täpsusta 6 599 702, malva@lakiauto.ee.
Tavatellimus saadetakse E, K ja R kell 14:00. Kaup saabub kuni 3'e tööpäevaga. Tavatellimusse lähevad ainult positiivse laojäägiga tooted. Lisaks tavatellimusele on võimalik tellida ka Express kulleriga (24h). Kulleri hinda täpsusta 6 599 702, malva@lakiauto.ee.
-
Thread Size: M12 x 1,
5 - Spanner Size: 19
- Number of pins: 2
- Colour Coding: blue
- Weight [kg]: 0.035
- Tootja: VEMO GERMANY
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Mootorikood: B201XL
-
Thread Size: 1/
8- 27NPT - Spanner Size: 13
-
Nimetus: ANDUR,
JAHUTUSVEDELIKU TEMP. - Tootja: EPS
- Ehitusaasta kuni: 09.1990
- Tootja: BOSCH
- Mootorikood: B201XL
- Number of pins: 2
- Weight [kg]: 0.05
- Tootja: ERA
- Mootorikood: B201XL
- Nimetus: DETONATSIOONIANDUR
- Tootja: EPS
Tootja: MAGNETI MARELLI
- Lambda andur: Sond
- Väljalaskesüsteem: katalüsaatori ees
- Lambda Sensor: Lambda Sensor
- Voltage [V]: 12
- Number of circuits: 1
- Weight [kg]: 0.08
- Operating Mode: Electric
- Warranty: 3 years warranty
- Tootja: SKV GERMANY
- Nimetus: CE 09SKV901
- Mootorikood: B201XL
- Number of connectors: 2
- Weight [kg]: 0.054
- Tootja: VEMO GERMANY
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Number of circuits: 3
- Lambda Sensor: Regulating Probe
- Tootja: KAMOKA
- Supplementary Article/Info 2: without cable
- Number of pins: 2
- Housing Colour: black
- Tootja: FAE
- Ehitusaasta alates: 09.1988
- Ehitusaasta kuni: 09.1990
- Lambda andur: Sond
- Installatsiooni pool: katalüsaatori ees
- Lambda Sensor: Heated
- Number of circuits: 3
-
Overall Length [mm]: 1,
270 - Nimetus: LAMBDA ANDUR
- Tootja: MAX
- Ehitusaasta kuni: 08.1988
- Lambda andur: Sond
- Installatsiooni pool: katalüsaatori ees
- Number of circuits: 1
-
Recommended change interval [km]: 80,
000 - Connector/Clamp: Connector may need adjustment
- Nimetus: LAMBDA ANDUR
- Tootja: BOS
-
Length [mm]: 1,
215 - Number of circuits: 3
- Resistor [Ohm]: 4.5
- Conductor Number: 3
-
Cable Length [mm]: 1,
215 - Lambda Sensor: Heated
- Tootja: MAGNETI MARELLI
- Lambda Sensor: Lambda Sensor
-
Cable Length [mm]: 1,
250 - Number of circuits: 3
- Tootja: ERA
- Number of circuits: 3
-
Overall Length [mm]: 1,
236 - Lambda Sensor: Heated
- Lisainfo: Lambda sensor
- Ehitusaasta alates: 09.1988
- Ehitusaasta kuni: 09.1990
- Lambda Sensor: Regulating Probe
- Voltage [V]: 12
-
Length [mm]: 1,
670 - Number of circuits: 3
- Weight [kg]: 0.23
- Resistor [Ohm]: 4.5
- Operating Mode: Electric
- Warranty: 3 years warranty
- Tootja: SKV GERMANY
- Nimetus: CE 09SKV546
- Ehitusaasta alates: 09.1988
- Ehitusaasta kuni: 09.1990
- Lambda andur: Sond
- Installatsiooni pool: katalüsaatori ees
- Tootja piirang: Bosch
- Number of circuits: 3
-
Recommended change interval [km]: 160,
000 - Connector/Clamp: Connector may need adjustment
- Nimetus: LAMBDA ANDUR
- Tootja: BOS
- Ehitusaasta alates: 09.1988
- Ehitusaasta kuni: 09.1990
- Lambda andur: Sond
- Installatsiooni pool: katalüsaatori ees
- Tootja piirang: Bosch
- Number of circuits: 3
-
Overall Length [mm]: 1,
236 - Available as universal article as well, see article no.: 0258986502
-
Recommended change interval [km]: 100,
000 - Nimetus: LAMBDA ANDUR
- Tootja: BOS
- for OE number: 75 01 612
- Weight [kg]: 0.025
- Tootja: VEMO GERMANY
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
Laki Auto universaaltooted
TecDoc sõidukite kataloog
TecDoc veokite kataloog