Tootekategooriad
Filter Pidurid Šassii Roolimine Jahutus/kliima Elektrisüsteem Lisad Jõuülekanne Väljalaskesüsteem Kere Süüte-/eelsüütesüsteem Mootor Klaasid/klaasipuhastus Valgustus Kütusesüsteemi seadmed Kabiinivarustus HooldusToode
Kirjeldus
Laoseis
Hind
(km-ga)
- Length [mm]: 446
-
Lambda Sensor: Heated,
Thread pre- greased - Number of circuits: 4
-
Fabrication Number: ESL-
CT- 012 - Tootja: NTY
-
Nimetus: NTY ESL-
CT- 012
Tavatellimus saadetakse E, K ja R kell 14:00. Kaup saabub kuni 3 tööpäevaga. Tavatellimusse lähevad ainult positiivse laojäägiga tooted. Lisaks tavatellimusele on võimalik tellida ka Express kulleriga (24h). Kulleri hinda täpsusta 6 599 702, malva@lakiauto.ee.
Tavatellimus saadetakse E, K ja R kell 14:00. Kaup saabub kuni 3'e tööpäevaga. Tavatellimusse lähevad ainult positiivse laojäägiga tooted. Lisaks tavatellimusele on võimalik tellida ka Express kulleriga (24h). Kulleri hinda täpsusta 6 599 702, malva@lakiauto.ee.
- Number of circuits: 4
- Lambda Sensor: Regulating Probe
- Tootja: KAMOKA
-
Lambda Sensor: Diagnostic Probe,
Thread pre- greased -
Fabrication Number: ESL-
SK- 000 - Tootja: NTY
-
Nimetus: NTY ESL-
SK- 000
Tavatellimus saadetakse E, K ja R kell 14:00. Kaup saabub kuni 3 tööpäevaga. Tavatellimusse lähevad ainult positiivse laojäägiga tooted. Lisaks tavatellimusele on võimalik tellida ka Express kulleriga (24h). Kulleri hinda täpsusta 6 599 702, malva@lakiauto.ee.
Tavatellimus saadetakse E, K ja R kell 14:00. Kaup saabub kuni 3'e tööpäevaga. Tavatellimusse lähevad ainult positiivse laojäägiga tooted. Lisaks tavatellimusele on võimalik tellida ka Express kulleriga (24h). Kulleri hinda täpsusta 6 599 702, malva@lakiauto.ee.
- Lambda andur: Diagnoosisond
- Lambda Sensor: Lambda Sensor
- Voltage [V]: 12
- Length [mm]: 536
- Number of circuits: 4
- Weight [kg]: 0.1
- Operating Mode: Electric
- Warranty: 3 years warranty
- Tootja: SKV GERMANY
- Nimetus: CE 09SKV062
- Lambda Sensor: Heated
-
External Thread Size: M18 x 1,
5 - Spanner Size: 22
- Number of circuits: 4
- Fitting Position: after catalytic converter
- Cable Length [mm]: 370
- Weight [kg]: 0.1
- Tootja: BLUEPRINT
General Information: These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.
- Lambda andur: Diagnoosisond
- Lambda Sensor: Lambda Sensor
- Voltage [V]: 12
- Length [mm]: 570
- Number of circuits: 4
- Weight [kg]: 0.13
- Resistor [Ohm]: 6
- Operating Mode: Electric
- Warranty: 3 years warranty
- Tootja: SKV GERMANY
- Nimetus: CE 09SKV703
- Lambda Sensor: Heated
-
External Thread Size: M18 x 1,
5 - Spanner Size: 22
- Number of circuits: 4
- Fitting Position: after catalytic converter
- Cable Length [mm]: 370
- Weight [kg]: 0.1
- Nimetus: SW 33 10 4608
- Tootja: SWAG
General Information: These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.
- Lambda Sensor: Lambda Sensor
- Cable Length [mm]: 290
- Alternatively:
- Number of circuits: 4
- Alternative Repair Kit: 570112
- Tootja: ERA
- Ehitusaasta kuni: 02.2011
- Lambda andur: Diagnoosisond
- Installatsiooni pool: pärast katalüsaatorit
- Number of circuits: 4
-
Recommended change interval [km]: 160,
000 - Connector/Clamp: Connector may need adjustment
- Tootja: BOSCH
- Nimetus: BS 0258986602
- Lambda Sensor: Regulating Probe
-
Fabrication Number: ESL-
CT- 008 - Tootja: NTY
Tavatellimus saadetakse E, K ja R kell 14:00. Kaup saabub kuni 3 tööpäevaga. Tavatellimusse lähevad ainult positiivse laojäägiga tooted. Lisaks tavatellimusele on võimalik tellida ka Express kulleriga (24h). Kulleri hinda täpsusta 6 599 702, malva@lakiauto.ee.
Tavatellimus saadetakse E, K ja R kell 14:00. Kaup saabub kuni 3'e tööpäevaga. Tavatellimusse lähevad ainult positiivse laojäägiga tooted. Lisaks tavatellimusele on võimalik tellida ka Express kulleriga (24h). Kulleri hinda täpsusta 6 599 702, malva@lakiauto.ee.
- Lambda Sensor: Diagnostic Probe
- Number of pins: 4
- Cable Length [mm]: 480
- Tootja: MEAT&DORIA
-
Mootorikood: 5FY
(EP6DTS), EP6DTS - Installatsiooni pool: pärast katalüsaatorit
- vajaminev tükihulk: 1
- Lambda andur: Diagnoosisond
- Cable Length [mm]: 450
- Conductor Number: 4
-
Lambda Sensor: Heated,
Planar probe, Thread pre- greased - Available as universal article as well, see article no.: 1.997.008
- Number of circuits: 4
- Nimetus: EP 1.998.078
- Tootja: EPS
-
Line insulation design: with silicone-
coated woven- fibre insulation - Length [mm]: 450
- Connector Shape: angular
- Conductor Number: 4
-
Thread Size: M18 x 1,
5 - Cable Length [mm]: 330
-
Lambda Sensor: Diagnostic Probe,
Thread pre- greased - Weight [kg]: 0.13
- Tootja: VEMO GERMANY
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Installatsiooni pool: pärast katalüsaatorit
-
Line insulation design: with silicone-
coated woven- fibre insulation -
Lambda Sensor: Planar probe,
Heated, Thread pre- greased - Cable Length [mm]: 210
- Number of circuits: 4
- Weight [kg]: 0.09
- Tootja: VEMO GERMANY
Supplementary Article/Supplementary Info: with squeeze connector, with shrink squeeze connector General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Installatsiooni pool: pärast katalüsaatorit
- Cable Length [mm]: 450
-
Lambda Sensor: Planar probe,
Heated - Tootja: DELPHI
-
Nimetus: DE ES20413-
12B1 - Kvaliteediklass: PJ
Lisainfo: "Tootja: DELPHI
(kvaliteediklass: PJ)"
- Väljalaskesüsteem: pärast katalüsaatorit
- Lambda andur: Diagnoosisond
- Length [mm]: 640
- Number of connectors: 4
- Tootja: VERNET
-
Lambda Sensor: Regulating Probe,
Thread pre- greased - Overall Length [mm]: 710
- Number of circuits: 5
- Fitting Position: before catalytic converter
-
Fabrication Number: ESL-
CT- 014 - Tootja: NTY
Lisainfo: ENG. 1.4,1.6 CITROEN C4 I 08-13, DS3 11-15, MINI (R56,R57,R58,R59) 06-15, CLUBMAN (R55) 07-14, PEUGEOT 207 06-13, 308 I 07-14, /REGULACYJNA, PRZED KATALIZATOREM, D.CAK.690MM
Tavatellimus saadetakse E, K ja R kell 14:00. Kaup saabub kuni 3 tööpäevaga. Tavatellimusse lähevad ainult positiivse laojäägiga tooted. Lisaks tavatellimusele on võimalik tellida ka Express kulleriga (24h). Kulleri hinda täpsusta 6 599 702, malva@lakiauto.ee.
- Lambda Sensor: Lambda Sensor
- Voltage [V]: 12
- Colour: red
- Number of circuits: 5
- Weight [kg]: 0.15
- Operating Mode: Electric
- Warranty: 3 years warranty
- Tootja: SKV GERMANY
- Nimetus: CE 09SKV905
-
Mootorikood: 5FY
(EP6DTS), EP6DTS - Installatsiooni pool: katalüsaatori ees
- vajaminev tükihulk: 1
- Lambda andur: Sond
- Cable Length [mm]: 720
- Conductor Number: 5
- Supplementary Article/Info 2: with fastening material
- Number of circuits: 5
- Nimetus: EP 1.998.478
- Tootja: EPS
Lambda Sensor: Heated, Planar probe, Broadband lambda sensor, Thread pre-greased
- Lambda andur: Diagnoosisond
- Installatsiooni pool: pärast katalüsaatorit
- Lambda Sensor: Heated
- Length [mm]: 450
- Number of pins: 4
- Socket colour: blue
- Technical Information Number: Universal 77004
- Tootja: FAE
- Lambda Sensor: Lambda Sensor
- Weight [kg]: 0.15
- Warranty: 3 years warranty
- Technical Information: Universal
- Nimetus: CE 09SKV915
- Tootja: ESEN SKV
- Ehitusaasta kuni: 02.2011
- Lambda andur: Sond
- Installatsiooni pool: katalüsaatori ees
- Number of circuits: 5
- Overall Length [mm]: 710
-
Recommended change interval [km]: 250,
000 - Tootja: BOSCH
-
Mootorikood: 5FY
(EP6DTS) - Installatsiooni pool: katalüsaatori ees
-
Line insulation design: with silicone-
coated woven- fibre insulation -
Thread Size: M18 x 1,
5 - Conductor Number: 5
- Connector Shape: D Shape
- Length [mm]: 700
- Alternatively:
- Number of pins: 5
-
Lambda Sensor: Regulating Probe,
Thread pre- greased - Exhaust System: before catalytic converter
- Weight [kg]: 0.156
- Tootja: VEMO GERMANY
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
Laki Auto universaaltooted
TecDoc sõidukite kataloog
TecDoc veokite kataloog