Tootekategooriad
Filter Pidurid Šassii Roolimine Jahutus/kliima Elektrisüsteem Lisad Jõuülekanne Väljalaskesüsteem Kere Süüte-/eelsüütesüsteem Mootor Klaasid/klaasipuhastus Valgustus Kütusesüsteemi seadmed Kabiinivarustus HooldusToode
Kirjeldus
Laoseis
Hind
(km-ga)
- Fitting Position: transmission sided
- Outer Diameter [mm]: 104
- Inner Diameter [mm]: 90
- Width [mm]: 11
- Tootja: JP GROUP
-
Lisainfo: Oil seal for crankshaft,
rear, silicone
- Installatsiooni pool: stirnseitig
-
Radial Shaft Seal Design: AW/
BS - Dust Cover: with dust lip
-
Swirl Type: Right-
hand Twist - Outer Diameter [mm]: 50
- Inner Diameter [mm]: 31
- Height [mm]: 8
- Tootja: DELLO AUTOMEGA
- Installatsiooni pool: stirnseitig
- vajaminev tükihulk: 2
- Fitting Position: Cylinder Head
- Inner Diameter [mm]: 35
- Outer Diameter [mm]: 48
- Height [mm]: 7
- Weight [kg]: 0.015
- Tootja: VAICO
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Installatsiooni pool: Silindripea
- Mootorikood: Z 24 XE
-
Material: MVQ
(silicone rubber) - Inner Diameter [mm]: 35
- Outer Diameter [mm]: 48
- Height [mm]: 7
- Radial Shaft Seal Design: A SL
-
Swirl Type: Right-
hand Twist -
Nimetus: VOLLI RONGASTIHEND,
NUKKVOLL - Tootja: REI
- Fitting Position: frontal sided
- Height [mm]: 8
- Outer Diameter 1 [mm]: 50
- Inner Diameter 1 [mm]: 31
- Tootja: BGA
- Inner Diameter 1 [mm]: 35
- Outer Diameter 1 [mm]: 48
- Height 1 [mm]: 7
-
Material: FPM
(fluoride rubber) -
Swirl Type: Right-
hand Twist - Dust Cover: with dust lip
-
Fitting Position: Engine,
Drive Axle - for OE number: 55352607
-
Nimetus: VOLLI RONGASTIHEND,
KIGUKAST - Tootja: COT
- vajaminev tükihulk: 2
- Installatsiooni pool: stirnseitig
- Inner Diameter [mm]: 35
- Outer Diameter [mm]: 48
- Height [mm]: 7
-
Radial Shaft Seal Design: AW/
BS -
Swirl Type: Right-
hand Twist -
Material: MVQ
(silicone rubber) - Dust Cover: with dust lip
- Tootja: ELRING
- vajaminev tükihulk: 2
- Mootorikood: Z 24 XE
- Plokieraldus:
- Installatsiooni pool: stirnseitig
- Inner Diameter [mm]: 35
- Outer Diameter [mm]: 48
- Height [mm]: 7
-
Nimetus: VOLLI RONGASTIHEND,
NUKKVOLL - Tootja: AJU
- Lisainfo: AJU15012600
- Fitting Position: Cylinder Head
- Weight [kg]: 0.016
- Tootja: VAICO
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Installatsiooni pool: stirnseitig
- Inner Diameter [mm]: 31
- Outer Diameter [mm]: 50
- Height [mm]: 8
-
Radial Shaft Seal Design: AW/
BS -
Swirl Type: Right-
hand Twist -
Material: FPM
(fluoride rubber) - Dust Cover: with dust lip
- Tootja: ELRING
- Fitting Position: frontal sided
- Inner Diameter 1 [mm]: 31
- Outer Diameter 1 [mm]: 50
- Height 1 [mm]: 8
-
Material: FPM
(fluoride rubber) -
Swirl Type: Right-
hand Twist - Dust Cover: with dust lip
-
Nimetus: VOLLI RONGASTIHEND,
VNTVOLL - Tootja: COT
- Installatsiooni pool: stirnseitig
- Mootorikood: Z 24 XE
-
Material: FPM
(fluoride rubber) - Inner Diameter [mm]: 31
- Outer Diameter [mm]: 50
- Height [mm]: 8
- Radial Shaft Seal Design: A SL
-
Swirl Type: Right-
hand Twist - Height 1 [mm]: 7
-
Nimetus: VOLLI RONGASTIHEND,
VNTVOLL - Tootja: REI
- Fitting Position: transmission sided
- Inner Diameter [mm]: 90
- Outer Diameter [mm]: 104
- Width [mm]: 11
- Tootja: DR MOTOR
- Nimetus: DRM 0715
- Fitting Position: transmission sided
- Height [mm]: 11
- Outer Diameter 1 [mm]: 104
- Inner Diameter 1 [mm]: 90
- Tootja: BGA
- Fitting Position: transmission sided
- Outer Diameter [mm]: 104
- Inner Diameter [mm]: 90
- Width [mm]: 11
- Tootja: JP GROUP
- Lisainfo: PAKENDIS 10 tk
- Width [mm]: 11
- Inner Diameter [mm]: 90
- Outer Diameter [mm]: 104
-
Material: FPM
(fluoride rubber) - Fitting Position: transmission sided
- Weight [kg]: 0.05
- Tootja: FEBI BILSTEIN
General Information: These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.
- Installatsiooni pool: stirnseitig
- Mootorikood: Z 24 XE
- Inner Diameter [mm]: 31
- Outer Diameter [mm]: 50
- Height [mm]: 8
-
Nimetus: VOLLI RONGASTIHEND,
VNTVOLL - Tootja: AJU
- Fitting Position: transmission sided
- Inner Diameter 1 [mm]: 90
- Outer Diameter 1 [mm]: 104
- Height 1 [mm]: 11
-
Material: FPM
(fluoride rubber)/ ACM (polyacrylate rubber) - Dust Cover: with dust lip
-
Swirl Type: Left-
hand Twist - for OE number: 71739336
- Tootja: CORTECO
- Nimetus: CO 20033412
- Installatsiooni pool: kastipoolselt
- Inner Diameter [mm]: 90
- Outer Diameter [mm]: 104
- Height [mm]: 11
- Radial Shaft Seal Design: ASW
-
Swirl Type: Left-
hand Twist -
Material: FPM
(fluoride rubber)/ ACM (polyacrylate rubber) - Dust Cover: with dust lip
- Tootja: ELRING
- Fitting Position: transmission sided
- Inner Diameter 1 [mm]: 90
- Outer Diameter 1 [mm]: 104
- Height 1 [mm]: 11
-
Material: FPM
(fluoride rubber) -
Swirl Type: Left-
hand Twist - Dust Cover: with dust lip
-
Nimetus: VOLLI RONGASTIHEND,
JAOTUSKAST - Tootja: COT
- Installatsiooni pool: kastipoolselt
- Mootorikood: Z 24 XE
- Inner Diameter [mm]: 90
- Outer Diameter [mm]: 104
- Height [mm]: 11
- Radial Shaft Seal Design: A SL
-
Swirl Type: Left-
hand Twist -
Nimetus: VOLLI RONGASTIHEND,
VNTVOLL - Tootja: REI
- Installatsiooni pool: kastipoolselt
- Mootorikood: Z 24 XE
- Inner Diameter [mm]: 90
- Outer Diameter [mm]: 104
- Height [mm]: 11
-
Nimetus: VOLLI RONGASTIHEND,
VNTVOLL - Tootja: AJU
Laki Auto universaaltooted
TecDoc sõidukite kataloog
TecDoc veokite kataloog