Tootekategooriad
Filter Pidurid Šassii Roolimine Jahutus/kliima Elektrisüsteem Lisad Jõuülekanne Väljalaskesüsteem Kere Süüte-/eelsüütesüsteem Mootor Klaasid/klaasipuhastus Valgustus Kütusesüsteemi seadmed Kabiinivarustus HooldusToode
Kirjeldus
Laoseis
Hind
(km-ga)
- Fitting Position: frontal sided
- Inner Diameter [mm]: 32
- Outer Diameter [mm]: 47
- Thickness [mm]: 10
- Lisainfo: PAKENDIS 10 tk
- Fitting Position: frontal sided
- Swirl Type: Alternating Twist
-
Material: FPM
(fluoride rubber)/ ACM (polyacrylate rubber) - Dust Cover: with dust lip
-
Fabrication Number: NUP-
VW- 010
Tavatellimus saadetakse E, K ja R kell 14:00. Kaup saabub kuni 3 tööpäevaga. Tavatellimusse lähevad ainult positiivse laojäägiga tooted. Lisaks tavatellimusele on võimalik tellida ka Express kulleriga (24h). Kulleri hinda täpsusta 6 599 702, malva@lakiauto.ee.
- Fitting Position: frontal sided
- Observe service information:
-
Swirl Type: Right-
hand Twist -
Material: PTFE
(polytetrafluoroethylene) - Dust Cover: with dust lip
-
Fabrication Number: NUP-
VW- 011
Tavatellimus saadetakse E, K ja R kell 14:00. Kaup saabub kuni 3 tööpäevaga. Tavatellimusse lähevad ainult positiivse laojäägiga tooted. Lisaks tavatellimusele on võimalik tellida ka Express kulleriga (24h). Kulleri hinda täpsusta 6 599 702, malva@lakiauto.ee.
-
Mootorikood: ADP,
AHL - Plokieraldus:
-
Kerenumber (VIN) kuni: -
> 8DX199999 - Fitting Position: frontal sided
-
Material: FPM
(fluoride rubber) - Inner Diameter 1 [mm]: 32
- Outer Diameter 1 [mm]: 47
- Height 1 [mm]: 10
- Swirl Type: Alternating Twist
- Dust Cover: with dust lip
- for OE number: 026103085D
-
Nimetus: VOLLI RONGASTIHEND,
NUKKVOLL - Tootja: COT
- Lisainfo: 12012709
- vajaminev tükihulk: 1
- Installatsiooni pool: stirnseitig
- Tootja: AIC
Üldine informatsioon: Our products are usually delivered without installation instructions. Installation may only be carried out by trained specialist technicians. Products supplied by us are exclusively intended for proper and appropriate use. The warranty is void in the event of improper, contrary to the intended purpose or unsuitable application or use. For electronic items that leave fault memory entries, it is essential to submit fault memory logs in the event of a claim. This consequently concerns all electronic items that are detected, monitored and controlled by the engine control unit, such as sensors of all kinds (e.g. NOX sensors, ABS sensors), mass airflow sensors, airbag slip rings, headlamp levelling control units, throttle valves, lambda sensors or EGR modules. If you encounter difficulties during a repair (troubleshooting max. 1 hr.), please contact technical support at: Phone: 040 - 25 30 66 55 Email: service@aic-germany.de This often avoids extensive troubleshooting that is disproportionate to normal repair times. The following applies to complaints: The more complete the processes are submitted, the faster they can be processed. Complete documentation includes the warranty application (incl. KBA no., chassis no., first registration, engine code, mileage), first and second installation invoice, fault memory log, guided troubleshooting and, if applicable, pictures. Incomplete documentation may result in rejection of the claim.
- Thickness [mm]: 10
- Inner Diameter [mm]: 32
- Outer Diameter [mm]: 47
-
Material: FPM
(fluoride rubber) - Fitting Position: frontal sided
- Weight [kg]: 0.03
- Tootja: FEBI BILSTEIN
- Lisainfo: FE03598
General Information: These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.
- Installatsiooni pool: Silindripea
- Mootorikood: ADP
-
Material: FPM
(fluoride rubber) - Inner Diameter [mm]: 32
- Outer Diameter [mm]: 47
- Height [mm]: 10
- Radial Shaft Seal Design: A SL
- Swirl Type: Alternating Twist
-
Nimetus: VOLLI RONGASTIHEND,
NUKKVOLL - Tootja: REI
-
Lisainfo: 81-
19299- 10
- Installatsiooni pool: stirnseitig
- Inner Diameter [mm]: 32
- Outer Diameter [mm]: 47
- Height [mm]: 10
- Radial Shaft Seal Design: ASW
- Swirl Type: Alternating Twist
-
Material: FPM
(fluoride rubber)/ ACM (polyacrylate rubber) - Dust Cover: with dust lip
- Alternative Repair Kit: 325.156
- Tootja: ELRING
- Lisainfo: 325.155 ELR
- Inner Diameter [mm]: 32
- Outer Diameter [mm]: 47
- Height [mm]: 10
-
Material: FPM
(fluoride rubber)/ ACM (polyacrylate rubber) - Dust Cover: with dust lip
- Swirl Type: Alternating Twist
- Fitting Position: frontal sided
- Tootja: TOPRAN
General Information: Any and all spare parts we supply are solely intended for the designated purpose as defined by us. Installation by trained personnel only. Our products are usually supplied without assembly instructions. Installation in vehicles other than those specified by us may lead to the exclusion of warranty.
- Installatsiooni pool: ees
- Ehitusaasta alates: 02.1999
- Inner Diameter [mm]: 32
- Outer Diameter [mm]: 47
- Height [mm]: 10
-
Swirl Type: Alternating Twist,
Right- hand Twist -
Material: PTFE
(polytetrafluoroethylene) - Dust Cover: with dust lip
- Tootja: TOPRAN
General Information: Any and all spare parts we supply are solely intended for the designated purpose as defined by us. Installation by trained personnel only. Our products are usually supplied without assembly instructions. Installation in vehicles other than those specified by us may lead to the exclusion of warranty.
- Installatsiooni pool: stirnseitig
- Inner Diameter [mm]: 32
- Outer Diameter [mm]: 47
- Height [mm]: 10
- Radial Shaft Seal Design: ASW
- Swirl Type: Alternating Twist
-
Material: FPM
(fluoride rubber) - Dust Cover: with dust lip
- Alternative Repair Kit: 325.155
- Tootja: ELRING
- Kõrgus (mm): 10
- Siseläbimõõt [mm]: 32
- Välisläbimõõt [mm]: 47
- Installatsiooni pool: stirnseitig
- Fitting Position: frontal sided
- Height [mm]: 10
- Inner Diameter [mm]: 32
- Outer Diameter [mm]: 47
-
Swirl Type: Right-
hand Twist - Tootja: DR MOTOR PRZEWODY PRZELEWOWE
- Nimetus: DRM 02227
- Installatsiooni pool: Silindripea
-
Mootorikood: AHL,
ANA, ARM - Plokieraldus:
-
Material: PTFE
(polytetrafluoroethylene), ACM (Polyacrylate) - Supplementary Article/Info 2: with mounting sleeve
- Inner Diameter [mm]: 32
- Outer Diameter [mm]: 47
- Height [mm]: 10
- Radial Shaft Seal Design: A SL
-
Swirl Type: Right-
hand Twist -
Nimetus: VOLLI RONGASTIHEND,
NUKKVOLL - Tootja: REI
-
Lisainfo: 81-
34367- 00 REIN
-
Mootorikood: AHL,
ANA, ARM -
Kerenumber (VIN) alates: 8DX200001 -
> - Plokieraldus:
- Fitting Position: frontal sided
- Inner Diameter 1 [mm]: 32
- Outer Diameter 1 [mm]: 47
- Height 1 [mm]: 10
-
Material: PTFE
(polytetrafluoroethylene) -
Swirl Type: Right-
hand Twist - Dust Cover: with dust lip
- for OE number: 038103085A
-
Nimetus: VOLLI RONGASTIHEND,
NUKKVOLL - Tootja: COT
- Lisainfo: 20026413
- Installatsiooni pool: stirnseitig
- Inner Diameter [mm]: 32
- Outer Diameter [mm]: 47
- Height [mm]: 10
- Radial Shaft Seal Design: ASW
-
Swirl Type: Right-
hand Twist - Dust Cover: with dust lip
- Observe mounting information:
- Tootja: ELRING
- Lisainfo: 129.780 ELR
Material: PTFE (polytetrafluoroethylene)/ACM (polyacrylate rubber) Installation Information: Mounting dry and without any additional oil and grease
- Fitting Position: Axle beam
- General Information: shaft oil seal
- Tootja: BORSEHUNG
-
Mootorikood: AHL,
ARM, ANA - Thickness [mm]: 10
- Inner Diameter [mm]: 32
- Outer Diameter [mm]: 47
- Rotation Direction: Clockwise rotation
-
Material: ACM
(Polyacrylate), PTFE (polytetrafluoroethylene) - Supplementary Article/Info 2: with mounting sleeve
- Fitting Position: frontal sided
- Weight [kg]: 0.01
- Observe service information:
- Tootja: FEBI BILSTEIN
General Information: These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.
- Number of Teeth: 44
- Engine Timing: Timing Belt
- Tootja: JP GROUP
- Lisainfo: Timing gear for camshaft
- Engine Timing: Timing Belt
- Number of Teeth: 44
- Inner Diameter [mm]: 22
- Outer Diameter [mm]: 132
- Width [mm]: 21
- Material: Steel
- Tootja: TOPRAN
General Information: Any and all spare parts we supply are solely intended for the designated purpose as defined by us. Installation by trained personnel only. Our products are usually supplied without assembly instructions. Installation in vehicles other than those specified by us may lead to the exclusion of warranty.
- Mootori juhtimine: Hammasrihm
- Üldine informatsioon: camshaft phnsing gear
- Tootja: VIKA
- Mootorikood: ADP
- Number of Teeth: 44
- Engine Timing: Timing Belt
- Weight [kg]: 0.49
-
Nimetus: HAMMASRATAS,
NUKKVOLL - Tootja: FEB
General Information: These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.
- Hammastehulk: 52
- Kõrgus (mm): 26
- Siseläbimõõt [mm]: 22
- Välisläbimõõt [mm]: 130
- Mootori juhtimine: Hammasrihm
- Nimetus: IJS 181017
- Tootja: IJS GROUP
- Outer Diameter [mm]: 47
- Thickness [mm]: 10
- Inner Diameter [mm]: 32
- Fitting Position: transmission sided
- Weight [kg]: 0.195
- Tootja: VAICO
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Mootorikood: AHL
- Ehitusaasta alates: 10.1996
-
Asend/kraad: 1-
5 -
Komponendinumber: 03-
3317 - Versioon: reworked head only
- Standardmõõt (TUND):
- Tootja: GLYCO
-
Mootorikood: ANA,
AHL, ARM, ADP - Plokieraldus:
- Length [mm]: 410
- Nimetus: NUKKVOLL
- Tootja: FRE
-
Mootorikood: AHL,
ANA, ARM, ADP - Plokieraldus:
- General Information: chilled cast iron
- Nimetus: NUKKVOLL
- Tootja: KS