Tootekategooriad
Filter Pidurid Šassii Roolimine Jahutus/kliima Elektrisüsteem Lisad Jõuülekanne Väljalaskesüsteem Kere Süüte-/eelsüütesüsteem Mootor Klaasid/klaasipuhastus Valgustus Kütusesüsteemi seadmed Kabiinivarustus HooldusToode
Kirjeldus
Laoseis
Hind
(km-ga)
-
Fitting Position: Rear Axle Left,
Rear Axle Right -
Mounting Type: Rubber-
Metal Mount - Tootja: JP GROUP
-
Lisainfo: Bearing for strut,
rear
- Seal Material: Paper
-
Fitting Position: Rear Axle Right,
Rear Axle Left - Weight [kg]: 0.001
- Tootja: FEBI
General Information: These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.
- Fitting Position: Upper
- Weight [kg]: 0.25
- Weight [g]: 250
- Tootja: METALCAUCHO
- Fitting Position: Rear Axle
- Required quantity: 1
- Weight [g]: 255
- Nimetus: IM 30809
- Tootja: ORIGINAL IMPERIUM
- Quantity Unit: Set
- Fitting Position: Rear Axle
- Weight [kg]: 0.253
- Tootja: VAICO
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
-
Material: Rubber/
Metal - Fitting Position: Rear Axle
- Weight [kg]: 0.228
- Supplementary Article/Info 2: without ball bearing
- Tootja: FEBI
General Information: These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.
- for OE number: 33 52 1 092 362 S1
-
Fitting Position: Rear Axle Left,
Rear Axle Right - Tootja: GSP
- Quantity per axle: 2
-
Fitting Position: Rear Axle Left,
Rear Axle Right - Tootja: SACHS
for OE number: 1 092 362, 1 137 972, 33 50 4 035 929, 33 52 1 092 362, 33 52 1 137 972, 4 035 929 SVHC: No information available, please contact the manufacturer!
-
Material: Rubber/
Metal - Fitting Position: Rear Axle
- Weight [kg]: 0.228
- Supplementary Article/Info 2: without ball bearing
- Tootja: SWAG
- Nimetus: SW 20 54 0008
General Information: These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.
- Fitting Position: Rear Axle
- Tootja: KAMOKA AMORTYZATORY
- Fitting Position: Front Axle
- for OE number: 6N0413175A
- Tootja: KAMOKA AMORTYZATORY
- Nimetus: Suspension strut support bearing left=right
- Kvaliteediklass: PJ
Lisainfo: "Tootja: SRL
BMW E36/E46
(kvaliteediklass: PJ)"
- Quantity per axle: 2
-
Fitting Position: Rear Axle Left,
Rear Axle Right - Nimetus: LMI 1066901
- Tootja: LEMFÃRDER
for OE number: 1 092 362, 1 137 972, 33 50 4 035 929, 33 52 1 092 362, 33 52 1 137 972, 4 035 929 SVHC: No information available, please contact the manufacturer!
- Fitting Position: Rear Axle
- Tootja: JAPKO
- Seal Material: Paper
-
Material: Rubber/
Metal - Fitting Position: Rear Axle
- Weight [kg]: 0.24
- Supplementary Article/Info 2: without ball bearing
- Supplementary Article/Supplementary Info: with attachment material
- Tootja: FEBI
General Information: These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.
- Nimetus: Shock absorber protection kit left+right
- Kvaliteediklass: Q
Lisainfo: "Tootja: POLCAR
ALFA ROMEO 33
(kvaliteediklass: Q)"
- Fitting Position: Rear Axle
- Tootja: KAMOKA AMORTYZATORY
- Installatsiooni pool: Tagasild
-
Šassii: M-
tehnikaga sõidukile - Tootja: JP GROUP
- Ehitusaasta alates: 07.1996
- Fitting Position: Rear Axle
-
Mounting Type: Rubber-
Metal Mount -
Supplementary Article/Supplementary Info: with seal,
Rolling Bearing is not required - Tootja: METZGER
- Installatsiooni pool: Esisild
- Warranty: 5 years warranty
- Packaging length [cm]: 22
- Packaging width [cm]: 11
- Nimetus: CFD PK4780
- Tootja: DACO
- Installatsiooni pool: Esisild
- Nimetus: CFD PK1510
- Tootja: DACO
- Nimetus: Shock absorber protection kit left+right
- Kvaliteediklass: Q
Lisainfo: "Tootja: POLCAR
3 COUPE (E46), 04.99
(kvaliteediklass: Q)"
- Seal Material: Paper
-
Material: Rubber/
Metal - Fitting Position: Rear Axle
- Weight [kg]: 0.24
- Supplementary Article/Info 2: without ball bearing
- Supplementary Article/Supplementary Info: with attachment material
- Tootja: SWAG
- Nimetus: SW 20 55 0001
General Information: These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.
-
Material: Rubber/
Metal - Supplementary Article/Supplementary Info: with seal
-
Fitting Position: Rear Axle Left,
Rear Axle Right - Tootja: AIC
General Information: Our products are usually delivered without installation instructions. Installation may only be carried out by trained specialist technicians. Products supplied by us are exclusively intended for proper and appropriate use. The warranty is void in the event of improper, contrary to the intended purpose or unsuitable application or use. For electronic items that leave fault memory entries, it is essential to submit fault memory logs in the event of a claim. This consequently concerns all electronic items that are detected, monitored and controlled by the engine control unit, such as sensors of all kinds (e.g. NOX sensors, ABS sensors), mass airflow sensors, airbag slip rings, headlamp levelling control units, throttle valves, lambda sensors or EGR modules. If you encounter difficulties during a repair (troubleshooting max. 1 hr.), please contact technical support at: Phone: 040 - 25 30 66 55 Email: service@aic-germany.de This often avoids extensive troubleshooting that is disproportionate to normal repair times. The following applies to complaints: The more complete the processes are submitted, the faster they can be processed. Complete documentation includes the warranty application (incl. KBA no., chassis no., first registration, engine code, mileage), first and second installation invoice, fault memory log, guided troubleshooting and, if applicable, pictures. Incomplete documentation may result in rejection of the claim.
- Installatsiooni pool: Tagasild
-
Šassii: M-
tehnikaga sõidukile - Fitting Position: Rear Axle both sides
- Nimetus: Shock absorber protection kit left+right
- Kvaliteediklass: PJ
Lisainfo: "Tootja: SRL
BMW E46
(kvaliteediklass: PJ)"
- Installatsiooni pool: Tagasild
- Weight [kg]: 0.3
- Supplementary Article/Info 2: without bearing
- Warranty: 5 years warranty
- Packaging length [cm]: 14
- Packaging width [cm]: 4.4
- Packaging height [cm]: 14.5
- Tootja: MONROE
- Nimetus: Shock absorber protection kit left+right
- Kvaliteediklass: PJ
Lisainfo: "Tootja: SRL
BMW/FIAT/SKODA FABIA
(kvaliteediklass: PJ)"
-
Material: PU
(Polyurethane), Plastic - Fitting Position: Rear Axle
- Weight [kg]: 0.192
- Tootja: FEBI
- Lisainfo: F13096
General Information: These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.
- Quantity per axle: 2
- Alternatively:
- Supplementary Article/Supplementary Info: with seal
-
Fitting Position: Rear Axle Left,
Rear Axle Right - Nimetus: LMI 3108601
- Tootja: LEMFÃRDER
for OE number: 1 092 362, 1 123 351, 1 125 554, 1 128 734, 1 128 819, 1 137 972, 33 52 1 092 362, 33 52 1 123 351, 33 52 1 125 554, 33 52 1 128 734, 33 52 1 128 819, 33 52 1 137 972, 33 52 6 772 864, 6 772 864 SVHC: No information available, please contact the manufacturer!
-
Installatsiooni pool: paremal,
vasakul, Tagasild - Width 1 [mm]: 33
- Inner Diameter 1 [mm]: 10
- Outer Diameter 1 [mm]: 47
- Nimetus: SN KB950.00
-
Tootja: NTN-
SNR
- Fitting Position: Rear Axle
- Tootja: KAYABA
- Nimetus: KY 915002
- Fitting Position: Rear Axle
-
Material: PU
(Polyurethane), Thermoplast - Weight [g]: 251
- Component Number: 4
- Nimetus: IM 50171
- Tootja: ORIGINAL IMPERIUM
-
Material: PU
(Polyurethane), Plastic - Fitting Position: Rear Axle
- Weight [kg]: 0.192
- Tootja: SWAG
- Nimetus: SW 20 91 3096
General Information: These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.
- Installatsiooni pool: Tagasild
- Weight [kg]: 0.4
- Warranty: 5 years warranty
- Packaging length [cm]: 22
- Packaging width [cm]: 11
- Packaging height [cm]: 18
- Tootja: MONROE
- Installatsiooni pool: Tagasild
-
Šassii: M-
tehnikaga sõidukile - Tootja: SACHS
SVHC: No information available, please contact the manufacturer!
- old version:
-
Material: Rubber/
Metal - Fitting Position: Front Axle
- Weight [kg]: 0.67
- Supplementary Article/Info 2: with ball bearing
- Tootja: FEBI
General Information: These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.
- old version:
-
Material: Rubber/
Metal - Fitting Position: Front Axle
- Weight [kg]: 0.67
- Supplementary Article/Info 2: with ball bearing
- Observe service information:
- Tootja: SWAG
General Information: These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.
- Installatsiooni pool: Tagasild
- Tootja: AUTOFREN REPERATURKI
-
Nimetus: SE D5-
009
Laki Auto universaaltooted
TecDoc sõidukite kataloog
TecDoc veokite kataloog