Tootekategooriad
Filter Pidurid Šassii Roolimine Jahutus/kliima Elektrisüsteem Lisad Jõuülekanne Väljalaskesüsteem Kere Süüte-/eelsüütesüsteem Mootor Klaasid/klaasipuhastus Valgustus Kütusesüsteemi seadmed Kabiinivarustus HooldusToode
Kirjeldus
Laoseis
Hind
(km-ga)
- Garantii: 3 aastat garantii
-
Kaal (kg): 0,
02 - Oluline on võrrelda vana uue osaga (eriti OE-numbrit):
- Tootja: SKV GERMANY
- Nimetus: CE 53SKV223
- Supplementary Article/Info 2: without bellow
- Tootja: VEMO GERMANY
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Piirangutega toode/piirangu info: koos lisadega
- Pistikkontaktide arv: 6
- Garantii: 3 aastat garantii
- Ülekandeliinide arv: 6
-
Kaal (kg): 0,
02 - Oluline on võrrelda vana uue osaga (eriti OE-numbrit):
- Tootja: SKV GERMANY
- Nimetus: CE 53SKV117
- Piirangutega toode/piirangu info: koos lisadega
- Pistikkontaktide arv: 2
- Garantii: 3 aastat garantii
- Ülekandeliinide arv: 2
-
Kaal (kg): 0,
02 - Oluline on võrrelda vana uue osaga (eriti OE-numbrit):
- Nimetus: CE 53SKV114
- Tootja: ESEN SKV
- Lisainfo: 53SKV114
- Pistikkontaktide arv: 32
- Garantii: 3 aastat garantii
-
Kaabli ristlõige [mm²]: 0,
5 -
Kaal (kg): 0,
07 - Kaablipikkus (mm): 150
- Oluline on võrrelda vana uue osaga (eriti OE-numbrit):
- Tootja: SKV GERMANY
- Nimetus: CE 53SKV268
- for OE number: 240660144
- Tootja: MEAT&DORIA
- Number of circuits: 1
- Length [mm]: 150
- Connector Shape: round
- Cable insulation material: Silicone
- Cross Section [mm²] from: 2.5
- for OE number: 240660016
-
Nimetus: Kaabli remondikomplekt,
hoogknal - Tootja: MD
- Lisainfo: 25026 MD
- Number of circuits: 1
- Length [mm]: 150
- Connector Shape: round
- Cable insulation material: Silicone
- Cross Section [mm²] from: 2.5
- for OE number: 240660002
-
Nimetus: Kaabli remondikomplekt,
hoogknal - Tootja: MD
- Lisainfo: 25002 MD
- Fitting Position: Engine Compartment
- Cable Length [mm]: 0
-
Mounting Type: Plug-
in connection - Supplementary Article/Supplementary Info: with plug insert
- short version:
- Number of circuits: 1
- Supplementary Article/Info 2: with multi plug
- Tootja: VEMO GERMANY
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Fitting Position: Engine Compartment
- Cable Length [mm]: 0
-
Mounting Type: Plug-
in connection - Supplementary Article/Supplementary Info: with plug insert
- Number of circuits: 1
- Tootja: VEMO GERMANY
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Length [mm]: 250
- Number of circuits: 1
- Cross Section [mm²] from: 0.75
- Cable insulation material: Silicone
- for OE number: 240660114
-
Nimetus: Paranduskomplekt,
kaablikomplekt - Tootja: MD
- Fitting Position: Engine Compartment
- Cable Length [mm]: 250
-
Mounting Type: Plug-
in connection - Supplementary Article/Supplementary Info: with shrink connector
- Supplementary Article/Info 2: with plug
- Number of circuits: 4
- Tootja: VEMO GERMANY
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Length [mm]: 100
- Number of pins: 5
- for OE number: 7M0973119
-
Nimetus: Paranduskomplekt,
kaablikomplekt - Tootja: MD
- Number of pins: 1
- for OE number: 028971782A
-
Nimetus: Kaabli remondikomplekt,
hoogknal - Tootja: MD
- Valgusti-ehitusliik: Ksenoon
- Anduritüüp: Hebelgeber
-
Tootja piirang: BMW/
FIAT/ FORD, MERCEDES/ VAG - Ülekandeliinide arv: 5
- Ühenduste arv: 6
- Kaablipikkus (mm): 100
-
Kaabli ristlõige alates [mm²]: 0,
5 -
Piirangutega toode/piirangu info: surve-
pressliidesega - Materjal: Silikoon
-
Kaabli ristlõige [mm²]: 0,
5 - Tootja: METZGER
- Cable Length [mm]: 317
-
Mounting Type: Plug-
in connection - Supplementary Article/Supplementary Info: with shrink connector
- Supplementary Article/Info 2: with plug
- Number of circuits: 6
- Number of pins (input) [-pin connector]: 6
- Cable Cross Section [mm²]: 1
- for OE number: 1J0 973 733
- Tootja: VEMO GERMANY
- Number of pins: 28
- Cable insulation material: Silicone
- Supplementary Article/Info 2: without bellow
- Length [mm]: 420
- Number of circuits: 28
-
Fitting Position: Left Rear,
Right Rear, Vehicle Door - for OE number: 240660020
-
Nimetus: Paranduskomplekt,
kaablikomplekt - Tootja: MD
- Number of circuits: 28
-
Fitting Position: Front and Rear,
both sides - Cable Length [mm]: 420
- Weight [kg]: 0.152
- Observe service information:
- Tootja: FEBI BILSTEIN
General Information: These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.
-
Fitting Position: Front,
Vehicle Door - Cable Length [mm]: 400
- Mounting Type: Partially assembled
- Supplementary Article/Supplementary Info: without shrink squeeze connector
-
Supplementary Article/Info 2: with vehicle-
specific adaptor - Number of circuits: 28
- Tootja: VEMO GERMANY
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Number of pins: 2
- Version: 25523
- for OE number: 028971766
-
Nimetus: Kaabli remondikomplekt,
hoogknal - Tootja: MD
- Number of pins: 2
- Version: 25524
- for OE number: 038971782B
-
Nimetus: Kaabli remondikomplekt,
hoogknal - Tootja: MD
- juhtmeisolatsiooni materjal: Silikoon
- Piirangutega toode/piirangu info: ilma lisavarustuseta
-
Materjal: CuSn
(vask- tina) - Kaablipikkus (mm): 400
- Ülekandeliinide arv: 28
-
Kaabli ristlõige kuni [mm²]: 2,
5 -
alternatiivne remondikomplekt: 2321033,
2321034 - Tootja: METZGER
Installatsiooni pool: Sõiduki uks, ees vasakul, ees paremal, taga vasakul, taga paremal
- Number of circuits: 28
- Supplementary Article/Supplementary Info: with shrink connector
-
Fitting Position: Front and Rear,
both sides - Cable Length [mm]: 420
- Weight [kg]: 0.176
- Observe service information:
- Tootja: FEBI BILSTEIN
General Information: These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.
- Fitting Position: Injector Nozzle
- Tootja: FEBI
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Fitting Position: Glow plug side
- Tootja: VEMO
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
Laki Auto universaaltooted
TecDoc sõidukite kataloog
TecDoc veokite kataloog