Tootekategooriad
Filter Pidurid Šassii Roolimine Jahutus/kliima Elektrisüsteem Lisad Jõuülekanne Väljalaskesüsteem Kere Süüte-/eelsüütesüsteem Mootor Klaasid/klaasipuhastus Valgustus Kütusesüsteemi seadmed Kabiinivarustus HooldusToode
Kirjeldus
Laoseis
Hind
(km-ga)
- Guarantee: 3 years guarantee
- Weight [kg]: 0.02
- Always compare old and new part (in particular OE No.):
- Nimetus: CE 53SKV223
- Tootja: ESEN SKV
- Supplementary Article/Supplementary Info: with accessories
- Number of pins: 6
- Guarantee: 3 years guarantee
- Number of circuits: 6
- Weight [kg]: 0.02
- Always compare old and new part (in particular OE No.):
- Tootja: SKV GERMANY
- Nimetus: CE 53SKV117
- Supplementary Article/Supplementary Info: with accessories
- Number of pins: 2
- Guarantee: 3 years guarantee
- Number of circuits: 2
- Weight [kg]: 0.02
- Always compare old and new part (in particular OE No.):
- Nimetus: CE 53SKV114
- Tootja: ESEN SKV
- Lisainfo: 53SKV114
- Number of pins: 32
- Guarantee: 3 years guarantee
- Cable Cross Section [mm²]: 0.5
- Weight [kg]: 0.07
- Cable Length [mm]: 150
- Always compare old and new part (in particular OE No.):
- Tootja: SKV GERMANY
- Nimetus: CE 53SKV268
- for OE number: 240660144
- Tootja: MEAT&DORIA
- Length [mm]: 250
- Number of circuits: 1
- Cross Section [mm²] from: 0.75
- Cable insulation material: Silicone
- for OE number: 240660114
-
Nimetus: Paranduskomplekt,
kaablikomplekt - Tootja: MD
- Fitting Position: Engine Compartment
- Cable Length [mm]: 250
-
Mounting Type: Plug-
in connection - Supplementary Article/Supplementary Info: with shrink connector
- Supplementary Article/Info 2: with plug
- Number of circuits: 4
- Tootja: VEMO GERMANY
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Length [mm]: 100
- Number of pins: 5
- for OE number: 7M0973119
-
Nimetus: Paranduskomplekt,
kaablikomplekt - Tootja: MD
- Ehitusaasta alates: 06.2002
- Cable Length [mm]: 150
- Supplementary Article/Info 2: without bellow
- Number of circuits: 3
- Tootja: VIEROL
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Light Design: Xenon
- Sensor Type: Lever Sensor
-
Manufacturer Restriction: BMW/
FIAT/ FORD, MERCEDES/ VAG - Number of circuits: 5
- Number of connectors: 6
- Cable Length [mm]: 100
- Cable cross-section from [mm²]: 0.5
- Supplementary Article/Supplementary Info: with shrink squeeze connector
- Material: Silicone
- Cable Cross Section [mm²]: 0.5
- Tootja: METZGER
- Cable Length [mm]: 317
-
Mounting Type: Plug-
in connection - Supplementary Article/Supplementary Info: with shrink connector
- Supplementary Article/Info 2: with plug
- Number of circuits: 6
- Number of pins (input) [-pin connector]: 6
- Cable Cross Section [mm²]: 1
- for OE number: 1J0 973 733
- Tootja: VEMO GERMANY
- Number of pins: 28
- Cable insulation material: Silicone
- Supplementary Article/Info 2: without bellow
- Length [mm]: 420
- Number of circuits: 28
-
Fitting Position: Left Rear,
Right Rear, Vehicle Door - for OE number: 240660020
-
Nimetus: Paranduskomplekt,
kaablikomplekt - Tootja: MD
- Number of circuits: 28
-
Fitting Position: Front and Rear,
both sides - Cable Length [mm]: 420
- Weight [kg]: 0.152
- Observe service information:
- Tootja: FEBI BILSTEIN
General Information: These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.
-
Fitting Position: Front,
Vehicle Door - Cable Length [mm]: 400
- Mounting Type: Partially assembled
- Supplementary Article/Supplementary Info: without shrink squeeze connector
-
Supplementary Article/Info 2: with vehicle-
specific adaptor - Number of circuits: 28
- Tootja: VEMO GERMANY
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Cable insulation material: Silicone
- Supplementary Article/Supplementary Info: without accessories
-
Material: CuSn
(copper- tin) - Cable Length [mm]: 400
- Number of circuits: 28
- Cable cross-section to [mm²]: 2.5
-
Alternative Repair Kit: 2321033,
2321034 - Tootja: METZGER
Fitting Position: Vehicle Door, Left Front, Right Front, Left Rear, Right Rear
- Number of circuits: 28
- Supplementary Article/Supplementary Info: with shrink connector
-
Fitting Position: Front and Rear,
both sides - Cable Length [mm]: 420
- Weight [kg]: 0.176
- Observe service information:
- Tootja: FEBI BILSTEIN
General Information: These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.
Laki Auto universaaltooted
TecDoc sõidukite kataloog
TecDoc veokite kataloog