Tootekategooriad
Filtrid Pidurid vedrustus/alusvanker Roolisüsteem Jahutus/kliima Elektrisüsteem Veokonks/lisad Jõuülekanne Väljalaskesüsteem Kere Süüte-/eelsüütesüsteem Mootor Klaasid/klaasipuhastus Valgustus Kütus Kabiinivarustus HooldusToode
Kirjeldus
Laoseis
Hind
(km-ga)
- Operating Mode: Electric
- Fuel Type: Petrol
- Flow rate [l/h]: 100
- Operating Pressure [bar]: 3
- Input Voltage [V]: 12
- Kvaliteediklass: PJ
- Nimetus: Fuel pump
- Operating Mode: Electric
- Tootja: KAMOKA
- Operating Mode: Electric
- Pressure [bar]: 1.2
- Lisainfo: Fuel pump with plastic filter
- Flow rate [l/h]: 80
- Operating Mode: Electric
- Input Voltage [V]: 13.5
- Fuel Type: Petrol
- Operating Pressure [bar]: 3
- Nimetus: KTUSEPUMP
- Tootja: MAG
- Operating Mode: Electric
- Pressure [bar]: 3
- Tootja: JP GROUP
- Lisainfo: Fuel Pump
- Operating Mode: Electric
- Pressure [bar]: 3
- Flow rate [l/h]: 80
-
Injection System: Multi Point Injection
(MPI) - for OE number: 8001063996073
- Tootja: MEAT & DORIA
- Operating Mode: Electric
- Fuel Type: Petrol
- Supplementary Article/Info 2: without pressure sensor
-
Supplementary Article/Supplementary Info: without gasket/
seal - Nimetus: KTUSEPUMP
- Tootja: DLP
- Pressure [bar]: 3
- Operating Mode: Electric
- Number of connectors: 2
- Flow rate [l/h]: 90
- Weight [kg]: 0.534
- Tootja: ERA
- Operating Mode: Electric
- Supplementary Article/Info 2: without swirl pot
- Operating Pressure [bar]: 4
- Supplementary Article/Supplementary Info: with holder
- Flow rate [l/h]: 90
- SVHC: No SVHC present!
-
Nimetus: POMPA PAL. WKAD VW POLO 1.4 98-
- Tootja: HBE
- Supplementary Article/Info 2: with filter
- Pressure [bar]: 3
- Weight [kg]: 0.55
- Operating Mode: Electric
- Nimetus: AI E10355
- Tootja: AIRTEX
- for OE number: 6N0.919.051K
- Tootja: KAMOKA
- Width [mm]: 115
- Operating Mode: Electric
- Voltage [V]: 12
- Length [mm]: 145
- Height [mm]: 110
- Pressure [bar]: 3
- Tootja: VEMO
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Pressure [bar]: 3
- Operating Mode: Electric
- Lisainfo: Fuel pump with housing
- Operating Mode: Electric
- Operating Pressure [bar]: 4
- Lisainfo: Fuel pump with housing
- Operating Pressure [bar]: 3
- Operating Mode: Electric
- Flow rate [l/h]: 80
-
Injection System: Multi Point Injection
(MPI) - Nimetus: Fuel feed unit
- Kvaliteediklass: PJ
Lisainfo: vw GOLF III, 92- (kvaliteediklass PJ)
- Pressure [bar]: 3
- Operating Mode: Electric
- Number of pins: 4
- Tootja: KAMOKA
- Voltage [V]: 12
- Fitting Position: in fuel tank
- Operating Mode: Electric
- Fuel Type: Petrol
- Guarantee: 4 years guarantee
- Weight [kg]: 0.98
- Always compare old and new part (in particular OE No.):
- Tootja: SKV GERMANY
- Nimetus: CE 02SKV773
- Operating Mode: Electric
- Diameter [mm]: 43
- Total Length [mm]: 140
- Diameter 1 [mm]: 8
- Number of connectors: 1
- Pressure [bar]: 3
- Pressure [psi]: 43.5
- Voltage [V]: 12
-
Supplementary Article/Supplementary Info: with holder,
without tank sender unit - Tootja: PIERBURG
- Flow rate [l/h]: 100
- Operating Mode: Electric
- Input Voltage [V]: 12
- Sensor Type: Lever Sensor
- Supplementary Article/Supplementary Info: with fuel sender unit
- Operating Pressure [bar]: 3
- Nimetus: KTUSE ETTEANDEMOODUL
- Tootja: MAG
- Pressure [bar]: 1.2
- Operating Mode: Electric
- Tootja: VEMO
for article number: V10-09-0801, V10-09-0801-1, V10-09-0826, V10-09-0826-1 General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Pressure [bar]: 3
- Operating Mode: Electric
- Number of pins: 4
- Flow rate [l/h]: 80
- Weight [kg]: 1.244
- Tootja: ERA
- Width [mm]: 115
- Length [mm]: 103
- Operating Mode: Electric
- Height [mm]: 145
- Pressure [bar]: 3
- Number of pins: 2
- Supplementary Article/Info 2: with swirl pot
- Tootja: VEMO
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Fitting Position: in fuel tank
-
Supplementary Article/Supplementary Info: with fastening/
mounting material - Supplementary Article/Info 2: with connector parts
- Operating Mode: Electric
- Nimetus: KTUSEPUMP
- Tootja: BOS
- Width [mm]: 102
- Length [mm]: 115
- Height [mm]: 145
- Operating Mode: Electric
- Pressure [bar]: 1.2
- Supplementary Article/Info 2: with swirl pot
- Tootja: VEMO
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Width [mm]: 102
- Length [mm]: 115
- Height [mm]: 145
- Operating Mode: Electric
- Operating Pressure [bar]: 4
- Supplementary Article/Info 2: with swirl pot
- Tootja: VEMO
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Operating Mode: Electric
- Diameter [mm]: 110.2
- Total Length [mm]: 140
- Diameter 1 [mm]: 8
- Number of connectors: 1
- Pressure [bar]: 3
- Pressure [psi]: 43.5
- Voltage [V]: 12
- Supplementary Article/Supplementary Info: without tank sender unit
- Tootja: PIERBURG
- Pressure [bar]: 3
- Supplementary Article/Supplementary Info: with holder
- Fuel Type: Petrol
- Supplementary Article/Info 2: with swirl pot
- Operating Mode: Electric
- Tootja: VDO
Laki Auto universaaltooted
TecDoc sõidukite kataloog
TecDoc veokite kataloog