• Engine Number from: 8204931
• Switch Pressure [bar]: 0.3
• Housing Colour: black
• Number of pins: 1
• Lisainfo: Oil Pressure Switch
• Additional information: Oil Pressure Switch

• Thread Size: M 14x1,5
• Colour: black
• Number of pins: 1
• Switch Pressure [bar]: 0.35
• Spanner Size: 24
• Supplementary Article/Supplementary Info: with seal
• for OE number: 1535416
• Manufacturer: DELLO AUTOMEGA

• Engine Number to: 1294808, 8204931
• Switch Pressure [bar]: 0.4
• Thread Size: M14x1.5
• Sensor Type: Closed-type Sensor
• Name: OLISURVELšLITUS
• Manufacturer: VER

• Switch Pressure [bar]: 0.6
• Thread Size: M14x1.5
• Sensor Type: Closed-type Sensor
• Manufacturer: VERNET

• Engine Code: 835 A2.046
• Engine Number to: 1294514
• Pressure [bar]: 0
• Thread Size: M14x1,5
• Spanner Size: 21
• Name: OLISURVELšLITUS
• Manufacturer: EPS

• Engine Code: 835 A2.046
• Engine Number from: 1294514
• Pressure [bar]: 0
• Thread Size: M14x1,5
• Spanner Size: 21
• Name: OLISURVELšLITUS
• Manufacturer: EPS

• Switch Pressure [bar]: 0.5
• Thread Size: M14x1.5
• Sensor Type: Closed-type Sensor
• Name: OLISURVELšLITUS
• Manufacturer: VER

• Engine Number from: 8204931
• Pressure [bar]: 5
• Housing Colour: black
• Thread Size: M14x1.5-6g
• Diameter [mm]: 21
• Spanner Size: 21
• Number of pins: 1
• Name: OLISURVELšLITUS
• Manufacturer: DLP
• Quality class: PJ

Additional information: "Tootja: DELPHI
(kvaliteediklass: PJ)" Lisainfo: "Tootja: DELPHI
(kvaliteediklass: PJ)"

• Construction Year to: 10.1994
• Switch Pressure [bar]: 0.5
• Number of pins: 1
• Weight [kg]: 0.039
• Thread Size: M 14 x 1,5
• Pressure [bar]: 0.5
• Manufacturer: VEMO GERMANY

General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.

• Pressure from [bar]: 0.2
• Pressure to [bar]: 0.5
• Thread Size: M14x1,50
• Spanner Size: 21
• Name: OLISURVELšLITUS
• Manufacturer: MAG

• Sensor Type: NTC Sensor
• Mounting Type: Bolted
• Connector Shape: rectangular
• Number of pins: 2
• Spanner Size: 21
• Thread Size: M12x1.5
• for OE number: 46477022
• Supplementary Article/Info 2: with seal ring
• Name: Andur,Jahutusvedeliku temp.
• Manufacturer: NRF

• Number of pins: 1
• Switch Pressure [bar]: 0.35
• Thread Size: M 14x1,5
• Colour: black
• Supplementary Article/Supplementary Info: with gaskets/seals
• for article number: 2324051
• Version: AM
• Manufacturer: METZGER

• Engine Code: 835 A2.046
• Thread Size: M12x1,5
• Spanner Size: 19
• Name: ANDUR,JAHUTUSVEDELIKU TEMP.
• Manufacturer: EPS

for article number: 1.880.100, 1.880.108, 1.880.141, 1.880.152, 1.880.153, 1.880.193

• Thread Size: M12 x 1,5
• Spanner Size: 19
• Number of pins: 2
• Supplementary Article/Info 2: with seal ring
• Manufacturer: ERA

• Engine Code: 835 A2.046
• Engine Number from: 1294514
• Thread Size: M14 x 1,5
• Spanner Size: 21
• Number of pins: 1
• Pressure [bar]: 0.3
• Manufacturer: AIC

General Information: Our products are usually delivered without installation instructions. Installation may only be carried out by trained specialist technicians. Products supplied by us are exclusively intended for proper and appropriate use. The warranty is void in the event of improper, contrary to the intended purpose or unsuitable application or use. For electronic items that leave fault memory entries, it is essential to submit fault memory logs in the event of a claim. This consequently concerns all electronic items that are detected, monitored and controlled by the engine control unit, such as sensors of all kinds (e.g. NOX sensors, ABS sensors), mass airflow sensors, airbag slip rings, headlamp levelling control units, throttle valves, lambda sensors or EGR modules. If you encounter difficulties during a repair (troubleshooting max. 1 hr.), please contact technical support at: Phone: 040 - 25 30 66 55 Email: service@aic-germany.de This often avoids extensive troubleshooting that is disproportionate to normal repair times. The following applies to complaints: The more complete the processes are submitted, the faster they can be processed. Complete documentation includes the warranty application (incl. KBA no., chassis no., first registration, engine code, mileage), first and second installation invoice, fault memory log, guided troubleshooting and, if applicable, pictures. Incomplete documentation may result in rejection of the claim.

• Number of pins: 1
• Switch pressure from [bar]: 0.2
• Switch pressure to [bar]: 0.5
• Thread Size: M 14x1,5
• Housing Type: without housing
• Colour: black
• Supplementary Article/Supplementary Info: with gaskets/seals
• Quality: IAM
• Manufacturer: METZGER

• Thread Size: M14x1.5
• Manufacturer: VERNET

• Number of pins: 2
• Manufacturer: ERA

• Construction Year from: 01.1994
• Manufacturer: MAGNETI MARELLI

• Engine Code: 835 A2.046
• Thread Size: M14x1,5
• Spanner Size: 19
• Name: ANDUR,SISENDOHU TEMPERATUUR
• Manufacturer: EPS

• Colour: black
• Cable Length [mm]: 450
• Number of pins: 2
• Weight [kg]: 0.052
• Resistor [Ohm]: 700
• Fitting Depth [mm]: 29.5
• Manufacturer: ERA

• Chemical Properties: Oil resistant
• Number of pins: 1
• Cable Length [mm]: 80
• Cable Cross Section [mm²]: 1
• Contact surface: Tin-plated
• Supplementary Article/Info 2: with copper casing, with protection hose
• Supplementary Article/Supplementary Info: with cable tie
• Temperature range from [°C]: -25
• Temperature range to [°C]: +125
• SVHC: No SVHC present!
• Name: šhenduskaabel, olisurvelliti
• Manufacturer: HBE

Manufacturer Restriction: Opel, Fiat, Peugeot, Alfa Romeo, Lancia, Suzuki, Ford, Citroen

• Number of circuits: 3
• Lambda Sensor: Regulating Probe
• Manufacturer: KAMOKA

• Lambda Sensor: Diagnostic Probe, Thread pre-greased
• Fabrication Number: ESL-SK-000
• Manufacturer: NTY
• Name: NTY ESL-SK-000

Manufacturer: MAGNETI MARELLI

• Construction Year to: 12.1996
• Operating Mode: Electric
• Manufacturer: MAGNETI MARELLI

• Lambda Sensor: Lambda Sensor
• Voltage [V]: 12
• Number of circuits: 3
• Weight [kg]: 0.08
• Operating Mode: Electric
• Warranty: 3 years warranty
• Name: CE 09SKV903
• Manufacturer: ESEN SKV

• Operating Mode: Electric
• Manufacturer: MAGNETI MARELLI

• Engine Code: 835 A2.046
• Construction Year from: 04.1993
• Cable Length [mm]: 750
• Manufacturer: FAE

• Engine Code: 835 A2.046
• Construction Year from: 04.1993
• Number of pins: 3
• Manufacturer: FAE

• Engine Code: 835 A2.046
• Name: EP 1.995.083
• Manufacturer: EPS

• Lambda Sensor: Lambda Sensor
• Length [mm]: 972
• Number of circuits: 4
• Manufacturer: FAST

• Length [mm]: 1,215
• Number of circuits: 3
• Resistor [Ohm]: 4.5
• Conductor Number: 3
• Cable Length [mm]: 1,215
• Lambda Sensor: Heated
• Manufacturer: MAGNETI MARELLI
• Name: MM OSM078

• Construction Year to: 06.1994
• Exhaust System: for pre-catalytic converter
• Quality: OE
• Thread Size: M18x1.5
• Cable Length [mm]: 750
• Number of pins: 3
• Weight [g]: 95
• Gross Weight [g]: 144
• Manufacturer: DENSO
• Name: Lambda sensor
• Quality class: Q

Lambda Sensor: Regulating Probe, Heated, Finger probe, Lambda Sensor Additional information: "Tootja: DENSO
ESCORT IV KOMBI (AWF
(kvaliteediklass: Q)" Lisainfo: "Tootja: DENSO
ESCORT IV KOMBI (AWF
(kvaliteediklass: Q)"

• Lambda Sensor: Lambda Sensor
• Cable Length [mm]: 1,250
• Number of circuits: 3
• Manufacturer: ERA

• Construction Year to: 10.1994
• Lambda Sensor: Regulating Probe
• Voltage [V]: 12
• Length [mm]: 985
• Number of circuits: 3
• Weight [kg]: 0.18
• Resistor [Ohm]: 4.5
• Operating Mode: Electric
• Warranty: 3 years warranty
• Name: CE 09SKV545
• Manufacturer: ESEN SKV

• Number of circuits: 3
• Overall Length [mm]: 1,236
• Lambda Sensor: Heated
• Lisainfo: Lambda sensor
• Additional information: Lambda sensor

• Construction Year to: 10.1994
• Lambda Sensor: Regulating Probe
• Voltage [V]: 12
• Length [mm]: 1,670
• Number of circuits: 3
• Weight [kg]: 0.23
• Resistor [Ohm]: 4.5
• Operating Mode: Electric
• Warranty: 3 years warranty
• Manufacturer: SKV GERMANY
• Name: CE 09SKV546

• Lambda Sensor: Regulating Probe
• Construction Year to: 10.1994
• Voltage [V]: 12
• Length [mm]: 1,215
• Number of circuits: 3
• Weight [kg]: 0.13
• Operating Mode: Electric
• Warranty: 3 years warranty
• Name: CE 09SKV066
• Manufacturer: ESEN SKV

• Engine Code: 835 A2.046
• Line insulation design: with silicone-coated woven-fibre insulation
• Diameter [mm]: 23.7
• Length [mm]: 995
• Cable Length [mm]: 950
• Lambda Sensor: Regulating Probe, Thread pre-greased
• Number of circuits: 3
• Weight [kg]: 0.166
• Manufacturer: VEMO GERMANY

General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.

• Engine Code: 835 A2.046
• Construction Year to: 10.1994
• Lambda Sensor: Regulating Probe
• Fitting Position: before catalytic converter
• Number of circuits: 3
• Recommended change interval [km]: 160,000
• Connector/Clamp: Connector may need adjustment
• Name: LAMBDA ANDUR
• Manufacturer: BOS