Assembly categories
Filters Brake System Axle Steering Cooling / AC Electrics Towbar/Accessories Transmission Exhaust System Body Ignition Engine Windscreen Cleaning Lights Fuel Supply Interior ServiceProduct
Description
In stock
Price
(incl. VAT)
- Model Year to: 1993
- Operating voltage [V]: 12
- Rated Power [W]: 480
- Rated current [A]: 40
- Combi Switch Function: Normally Open Contact
- Number of pins: 4
-
Lisainfo: Relay,
12 Volt, 40 Amp -
Additional information: Relay,
12 Volt, 40 Amp
Relay function: Terminal 75, Interior Blower, Suction pipe pre-heating, Sunroof, Pump, fuel pre-supply, Start-stop system, Magnetic clutch, Surge protection, Battery main switch, Engine control unit, Normally open contact, X contact relief, Fan, engine cooling, Electric booster heater, Secondary Air System, Water pump after-run, Rear Window Wiper, heater/air conditioning, Clamp 15, Fuel Pump, Window Regulator, Heated windscreen, Heated rear window, Parking Heater
- Rated Voltage [V]: 12
- Rated current [A]: 30
- Supplementary Article/Supplementary Info: without holder
- Number of pins: 5
-
Temperature range from [°C]: -
40 - Temperature range to [°C]: 100
- Housing Type: Synthetic Material Housing
- General Information: Multifunctional relay
- Manufacturer: VIKA
Combi Switch Function: without light dimmer function, Normally Open Contact
- Number of connectors: 4
- Rated Voltage [V]: 12
- Rated current [A]: 40
-
Temperature range from [°C]: -
40 - Temperature range to [°C]: 85
- General Information: Multifunctional relay; 4 claws
- Manufacturer: VIKA
- General Information: Multifunctional relay
- Manufacturer: VIKA
- Number of pins: 4
- Voltage [V]: 12
- Current Strength [A]: 70
- Relay function: Normally open contact
- Manufacturer: AIC
General Information: Our products are usually delivered without installation instructions. Installation may only be carried out by trained specialist technicians. Products supplied by us are exclusively intended for proper and appropriate use. The warranty is void in the event of improper, contrary to the intended purpose or unsuitable application or use. For electronic items that leave fault memory entries, it is essential to submit fault memory logs in the event of a claim. This consequently concerns all electronic items that are detected, monitored and controlled by the engine control unit, such as sensors of all kinds (e.g. NOX sensors, ABS sensors), mass airflow sensors, airbag slip rings, headlamp levelling control units, throttle valves, lambda sensors or EGR modules. If you encounter difficulties during a repair (troubleshooting max. 1 hr.), please contact technical support at: Phone: 040 - 25 30 66 55 Email: service@aic-germany.de This often avoids extensive troubleshooting that is disproportionate to normal repair times. The following applies to complaints: The more complete the processes are submitted, the faster they can be processed. Complete documentation includes the warranty application (incl. KBA no., chassis no., first registration, engine code, mileage), first and second installation invoice, fault memory log, guided troubleshooting and, if applicable, pictures. Incomplete documentation may result in rejection of the claim.
- Voltage [V]: 12
- Weight [kg]: 0.025
- Number of connectors: 4
- Current Strength [A]: 30
- Supplementary Article/Supplementary Info: with holder
- General Information: Multifunctional relay
- Manufacturer: BORSEHUNG
- General Information: Multifunctional relay
- Manufacturer: BORSEHUNG
-
Relay function: Pre-
glow device, X contact relief - Rated Voltage [V]: 12
- Number of connectors: 4
- Current Strength [A]: 70
- Relay Number: 644
- General Information: Multifunctional relay
- Manufacturer: BORSEHUNG
- Model Year to: 1993
- Operating voltage [V]: 12
- Rated Power [W]: 480
- Rated current [A]: 40
- Combi Switch Function: Normally Open Contact
- Length [mm]: 28
- Width [mm]: 28
- Height [mm]: 25
-
Connector type: 2x 6,
3 mm, 2x 9, 5 mm - Number of pins: 4
- Manufacturer: MEYLE
Relay function: Fuel Pump, Engine control unit, Surge protection, Suction pipe pre-heating, Interior Blower, Heated rear window, Battery main switch, Heated windscreen, Fan, heater/air conditioning, Rear Window Wiper, Water pump after-run, Secondary Air System, Electric booster heater, engine cooling, Normally open contact, Clamp 15, Parking Heater, X contact relief, Window Regulator, Terminal 75, Sunroof, Pump, fuel pre-supply, Start-stop system, Magnetic clutch
- Relay function: Ignition Switch
- Current Strength [A]: 70
- for OE number: 7752313
- Manufacturer: MEAT&DORIA
- Üldine informatsioon: Hazard light relay
- Manufacturer: BORSEHUNG
- Construction Year to: 07.1995
- for OE number: 8E0 951 253
-
Combi Switch Function: On/
Off Switch - Current Strength [A]: 70
- Voltage [V]: 12
- Number of pins: 4
- Relay function: Normally open contact
- Housing Type: Housing with Plastic Lid
- Protection Type (IP Code): IP20
-
Temperature range from [°C]: -
40 - Temperature range to [°C]: 85
- Housing Colour: black
- Resistor [Ohm]: 63
- Length [mm]: 28
- Width [mm]: 28
- Height [mm]: 40
- Manufacturer: BOSCH
- Construction Year to: 07.1995
- for OE number: 019 193 750 3
- Current Strength [A]: 70
- Voltage [V]: 12
- Number of pins: 4
- Relay function: Normally open contact
-
Temperature range from [°C]: -
40 - Temperature range to [°C]: 85
- Manufacturer: BOSCH
- Voltage [V]: 12
-
Relay function: Central electrics,
Normally open contact -
Current Strength [A]: 10,
25 - Number of connectors: 5
- Relay Number: 219
- Number of used contacts: 5
- Fitting Position: Engine Compartment
- Manufacturer: VEMO GERMANY
-
Lisainfo: V10-
71- 0001 VEM -
Additional information: V10-
71- 0001 VEM
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
Laki Auto universal products
TecDoc catalogue for cars
TecDoc catalogue for trucks