Assembly categories
Filters Brake System Axle Steering Cooling / AC Electrics Towbar/Accessories Transmission Exhaust System Body Ignition Engine Windscreen Cleaning Lights Fuel Supply Interior ServiceProduct
Description
In stock
Price
(incl. VAT)
- Fitting Position: frontal sided
- Outer Diameter [mm]: 47
- Inner Diameter [mm]: 32
- Width [mm]: 10
-
Manufacturer: JP GROUP A/
S - Lisainfo: PAKENDIS 10 tk
- Additional information: PAKENDIS 10 tk
- Fitting Position: frontal sided
- Inner Diameter [mm]: 32
- Outer Diameter [mm]: 47
- Thickness [mm]: 10
- General Information: Oil seal for camshaft; 47*10*32
- Manufacturer: VIKA
- Fitting Position: Front
- Inner Diameter [mm]: 35
- Outer Diameter [mm]: 48
- Height [mm]: 10
-
Fabrication Number: NUP-
VW- 012 - Manufacturer: NTY
Tavatellimus saadetakse E, K ja R kell 14:00. Kaup saabub kuni 3'e tööpäevaga. Tavatellimusse lähevad ainult positiivse laojäägiga tooted. Lisaks tavatellimusele on võimalik tellida ka Express kulleriga (24h). Kulleri hinda täpsusta 6 599 702, malva@lakiauto.ee.
- Fitting Position: frontal sided
- Inner Diameter [mm]: 35
- Outer Diameter [mm]: 48
- Height [mm]: 10
- Dust Cover: with dust lip
- Manufacturer: TOPRAN HANS PRIES
Material: PTFE (polytetrafluoroethylene)/ACM (polyacrylate rubber) General Information: Any and all spare parts we supply are solely intended for the designated purpose as defined by us. Installation by trained personnel only. Our products are usually supplied without assembly instructions. Installation in vehicles other than those specified by us may lead to the exclusion of warranty.
- Fitting Position: frontal sided
- for manufacturer number: 8707030
- Manufacturer: KAMOKA
- Fitting Position: frontal sided
- Inner Diameter [mm]: 35
- Outer Diameter [mm]: 48
- Width [mm]: 10
-
Lisainfo: Oil seal,
35x48x10 -
Additional information: Oil seal,
35x48x10
Material: PTFE (polytetrafluoroethylene)/ACM (polyacrylate rubber)
- Fitting Position: frontal sided
- Inner Diameter [mm]: 35
- Outer Diameter [mm]: 48
- Height [mm]: 10
-
Swirl Type: Right-
hand Twist - Radial Shaft Seal Design: ASW
- Manufacturer: DR MOTOR PRZEWODY PRZELEWOWE
- Name: DRM 01969
- Fitting Position: frontal sided
- for manufacturer number: 8707007
- Manufacturer: KAMOKA
- Fitting Position: frontal sided
- General Information: Oil seal for crankshaft; front
- Manufacturer: BORSEHUNG
- Thickness [mm]: 10
- Inner Diameter [mm]: 35
- Outer Diameter [mm]: 48
- Fitting Position: frontal sided
- Weight [kg]: 0.01
- Observe service information:
- Manufacturer: FEBI BILSTEIN
General Information: These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.
- Fitting Position: frontal sided
- Height [mm]: 10
- Outer Diameter [mm]: 48
- Inner Diameter [mm]: 35
- Manufacturer: BGA
Material: NBR (nitrile butadiene rubber), PTFE (polytetrafluoroethylene)
- Fitting Position: frontal sided
- Engine Code: BRD
- Height [mm]: 10
- Outer Diameter [mm]: 48
- Inner Diameter [mm]: 35
-
Material: PTFE
(polytetrafluoroethylene) - for OE number: 034115147A
- Manufacturer: FAI
- Fitting Position: frontal sided
- Engine Code: BRD
-
Material: PTFE
(polytetrafluoroethylene), ACM (Polyacrylate) - Supplementary Article/Info 2: with mounting sleeve
- Inner Diameter [mm]: 35
- Outer Diameter [mm]: 48
- Height [mm]: 10
- Radial Shaft Seal Design: A SL
-
Swirl Type: Right-
hand Twist -
Name: VOLLI RONGASTIHEND,
VNTVOLL - Manufacturer: REI
- Fitting Position: frontal sided
- Inner Diameter [mm]: 35
- Outer Diameter [mm]: 48
- Height [mm]: 10
- Radial Shaft Seal Design: ASW
-
Swirl Type: Right-
hand Twist - Dust Cover: with dust lip
- Supplementary Article/Info 2: with mounting sleeve
- Observe mounting information:
- Manufacturer: ELRING
Material: PTFE (polytetrafluoroethylene)/ACM (polyacrylate rubber) Installation Information: Mounting dry and without any additional oil and grease
- Engine Code: BRD
- Fitting Position: frontal sided
- Supplementary Article/Info 2: with mounting sleeve
- Height 1 [mm]: 10
- Outer Diameter 1 [mm]: 48
- Inner Diameter 1 [mm]: 35
-
Material: PTFE
(polytetrafluoroethylene) - for OE number: 038103085
-
Swirl Type: Right-
hand Twist - Dust Cover: with dust lip
-
Name: VOLLI RONGASTIHEND,
VNTVOLL - Manufacturer: COT
- Fitting Position: frontal sided
- Engine Code: BRD
- Inner Diameter [mm]: 35
- Outer Diameter [mm]: 48
- Height [mm]: 10
-
Swirl Type: Right-
hand Twist -
Name: VOLLI RONGASTIHEND,
VNTVOLL - Manufacturer: AJU
- Fitting Position: transmission sided
-
Fabrication Number: NUP-
VW- 023 - Manufacturer: NTY
Tavatellimus saadetakse E, K ja R kell 14:00. Kaup saabub kuni 3'e tööpäevaga. Tavatellimusse lähevad ainult positiivse laojäägiga tooted. Lisaks tavatellimusele on võimalik tellida ka Express kulleriga (24h). Kulleri hinda täpsusta 6 599 702, malva@lakiauto.ee.
- for OE number: 03G 105 021 C
- Thickness [mm]: 10
- Inner Diameter [mm]: 35
- Fitting Position: frontal sided
- Outer Diameter [mm]: 48
- Manufacturer: VAICO
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
- Fitting Position: transmission sided
- Housing Type: with housing
- Housing material: Plastic
- Supplementary Article/Supplementary Info: with pulse generator wheel
- Manufacturer Restriction: KACO
-
Sealing lip material: PTFE
(polytetrafluoroethylene) - Manufacturer: TOPRAN
General Information: Any and all spare parts we supply are solely intended for the designated purpose as defined by us. Installation by trained personnel only. Our products are usually supplied without assembly instructions. Installation in vehicles other than those specified by us may lead to the exclusion of warranty.
- Fitting Position: transmission sided
- Inner Diameter [mm]: 85
- Housing Type: Integrated housing
- Supplementary Article/Info 2: without integrated magnetic sensor ring
- Manufacturer: DR MOTOR
- Fitting Position: transmission sided
- Engine Code: BRD
- Height [mm]: 6.3
- Outer Diameter [mm]: 101
- Inner Diameter [mm]: 85
-
Material: PTFE
(polytetrafluoroethylene) - for OE number: 68000669AA
- Manufacturer: FAI
- Name: FAI OS1360
- Fitting Position: transmission sided
- Weight [kg]: 0.22
- Inner Diameter [mm]: 85
- Required quantity: 1
- Supplementary Article/Info 2: with flange
- General Information: Oil sealing flange for crankshaft; rear
- Manufacturer: VIKA
- Fitting Position: transmission sided
-
Material: PTFE
(polytetrafluoroethylene) -
Lisainfo: Shaft Seal,
crankshaft -
Additional information: Shaft Seal,
crankshaft
- Fitting Position: transmission sided
- Inner Diameter [mm]: 85
- Housing Type: Integrated housing
- Supplementary Article/Info 2: with integrated magnetic sensor ring
-
Name: Volli rongastihend,
Vntvoll - Manufacturer: DRM
- Fitting Position: transmission sided
- Height [mm]: 16
- Outer Diameter [mm]: 165
- Inner Diameter [mm]: 132
- Housing Type: with housing
- Manufacturer: BGA
- Inner Diameter [mm]: 85
-
Material: PTFE
(polytetrafluoroethylene) - Fitting Position: transmission sided
- Weight [kg]: 0.22
- Supplementary Article/Info 2: with flange
- Observe service information:
- Manufacturer: FEBI BILSTEIN
General Information: These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.
- Fitting Position: transmission sided
- Supplementary Article/Info 2: with mounting sleeve
- Height 1 [mm]: 16.5
- Outer Diameter 1 [mm]: 131
- Outer Diameter 2 [mm]: 153
- Inner Diameter 1 [mm]: 85
-
Name: VOLLI RONGASTIHEND,
VNTVOLL - Manufacturer: COT
Material: PPS (polyphen. sulfide)/TFE (tetrafluoroet.)/ACM (polyacryl)
- Fitting Position: transmission sided
- Engine Code: BRD
-
Material: PTFE
(polytetrafluoroethylene) - Supplementary Article/Info 2: with flange
-
Name: VOLLI RONGASTIHEND,
VNTVOLL - Manufacturer: REI
- Fitting Position: transmission sided
- Observe mounting information:
- Inner Diameter [mm]: 85
- Radial Shaft Seal Design: IWD
-
Swirl Type: Left-
hand Twist -
Material: PTFE
(polytetrafluoroethylene) - Housing Type: with housing
- Article number of the recommended special tool: VW T10134
- Supplementary Article/Info 2: with mounting sleeve
- Manufacturer: ELRING
Installation Information: Mounting dry and without any additional oil and grease
- Fitting Position: transmission sided
- Engine Code: BRD
- Inner Diameter [mm]: 132
- Outer Diameter [mm]: 165
- Height [mm]: 16
-
Swirl Type: Left-
hand Twist -
Material: PTFE
(polytetrafluoroethylene) - Housing Type: with housing
-
Name: Volli rongastihend,
Vntvoll - Manufacturer: AJU
Laki Auto universal products
TecDoc catalogue for cars
TecDoc catalogue for trucks