Assembly categories
Filters Brake System Axle Steering Cooling / AC Electrics Towbar/Accessories Transmission Exhaust System Body Ignition Engine Windscreen Cleaning Lights Fuel Supply Interior ServiceProduct
Description
In stock
Price
(incl. VAT)
- Model Year to: 2011
- Operating voltage [V]: 12
- Rated Power [W]: 480
- Rated current [A]: 40
- Combi Switch Function: Normally Open Contact
- Number of pins: 4
-
Lisainfo: Relay,
12 Volt, 40 Amp -
Additional information: Relay,
12 Volt, 40 Amp
Relay function: Terminal 75, Interior Blower, Suction pipe pre-heating, Sunroof, Pump, fuel pre-supply, Start-stop system, Magnetic clutch, Surge protection, Battery main switch, Engine control unit, Normally open contact, X contact relief, Fan, engine cooling, Electric booster heater, Secondary Air System, Water pump after-run, Rear window wiper, heater/air conditioning, Clamp 15, Fuel Pump, Window Regulator, Heated windscreen, Heated rear window, Parking Heater
- Number of connectors: 4
Lisainfo: Relay for fuel pump and intake manifold heating, 12 Volt, 40 Amp Additional information: Relay for fuel pump and intake manifold heating, 12 Volt, 40 Amp
- Rated current [A]: 40
- Combi Switch Function: Normally Open Contact
- Temperature range to [°C]: 85
- Resistor [Ohm]: 560
-
Connector type: 1x 2,
8 mm, 2x 6, 3 mm, 2x 9, 5 mm - Number of pins: 5
- Lisainfo: Multifunctional Relay
- Additional information: Multifunctional Relay
Relay function: Restart lock, Clamp 15, Terminal 50, Start-stop system, Starter, Engine control unit, Normally open contact
- for OE number: 4H0 951 253 C
- Current Strength [A]: 30
- Voltage [V]: 12
- Number of pins: 5
- Relay function: Normally open contact
- Protection Type (IP Code): IP5K4
-
Temperature range from [°C]: -
40 - Temperature range to [°C]: 100
- Resistor [Ohm]: 16
- Manufacturer: BOSCH
- Name: BS 0332201107
- Voltage [V]: 12
- Weight [kg]: 0.025
- Number of connectors: 4
- Current Strength [A]: 30
- Supplementary Article/Supplementary Info: with holder
- General Information: relay
- Manufacturer: BORSEHUNG
- Combi Switch Function: without light dimmer function
- Current Strength [A]: 20
- Voltage [V]: 24
- Number of pins: 5
- Relay function: Normally open contact
-
Temperature range from [°C]: -
40 - Temperature range to [°C]: 125
- Supplementary Article/Supplementary Info: with holder
- Resistor [Ohm]: 360
- Manufacturer: BOSCH
- General Information: relay
- Manufacturer: BORSEHUNG
-
Relay Number: 67,
80, 167 - Number of connectors: 4
- Weight [kg]: 0.035
- Manufacturer: FEBI BILSTEIN
General Information: These products are designed to be used as originally intended and not modified for purpose. Please ensure the products are installed by a competent individual. N.B. products are usually supplied without fitting instructions.
- General Information: relay
- Manufacturer: BORSEHUNG
- General Information: relay
- Manufacturer: BORSEHUNG
-
Relay function: Pre-
glow device, X contact relief - Rated Voltage [V]: 12
- Number of connectors: 4
- Current Strength [A]: 70
- Relay Number: 644
- General Information: relay
- Manufacturer: BORSEHUNG
- General Information: relay
- Manufacturer: BORSEHUNG
-
Relay function: Pre-
glow device, X contact relief - Rated Voltage [V]: 12
- Number of connectors: 4
- Current Strength [A]: 70
- Relay Number: 644
- General Information: relay
- Manufacturer: BORSEHUNG
- Lisainfo: B17818
- Additional information: B17818
- Current Strength [A]: 40
-
Relay function: Terminal 30,
Clamp 87 - Rated current [A]: 40
- Weight [kg]: 0.04
- Manufacturer: VEMO
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
-
Vehicle Identification Number (VIN) to: 3C-
B- 050 000 -
Vehicle Identification Number (VIN) from: 3C-
B- 200 001 - Voltage [V]: 12
- Current Strength [A]: 40
-
Relay function: Clamp 87,
Terminal 30 - Number of connectors: 4
- Weight [kg]: 0.027
- Fitting Position: Engine Compartment
- Manufacturer: VEMO
General Information: In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events.
Laki Auto universal products
TecDoc catalogue for cars
TecDoc catalogue for trucks